Great Plains 3PYP Predelivery Manual - Manual (Page 51)

Tractor Setup and Options 47
07/19/2011 401-312Q
John Deere 8000 ILS Installation
Refer to Figure 79 and Figure 80
The sensor
is installed at the rear of the right front
axle, close to the drive shaft.
8. Turn the tractor to the left to open room to work.
JD ILS: Mount Inside (Base End) Bracket
9.
Select one:
411-578D BRKT SENSOR JD SUSPEN WHL
10. Loosen the existing bolt just aft and lower at the
inboard universal joint. Slide the bracket tab with the
open slotted hole under the bolt head. Align so the
other tab is up and horizontal. Re-secure bolt
.
JD ILS: Mount Outside (Rod End) Bracket
Refer to Figure 79 and Figure 81 on page 48
11. Select one:
411-577D BRKT SENSOR JD SUSPEN FIXED
12. Remove the existing bolt . Using the same bolt,
secure the long tab (with the larger hole) of the
bracket
with the short tab facing forward and
right.
13. Turn the tractor front wheels straight forward.
Shut off tractor.
FigureSpacer: JD ILS: Check Sensor Extension
14. Select the sensor assembly . Loosen the gimbal
collar . Gently pull the sensor rod to centered
extension, as determined at step 7 on page 42, with
yoke center bolt down, and rod-end bolt up.
Note: When trial fitting, make sure sensor does not con-
tact any tractor components. Use alternate mount
and pivot holes as necessary to obtain clearance.
15. Determine which bracket holes sensor fits. Mark
those holes, but do not mount the sensor at this
time. At the inboard end, use the left end tab hole
if possible. At the outboard end, use center tab
hole
if possible.
If sensor is too short, move collar toward connector
end (base) of sensor. Do not block vent hole. If sen-
sor is still too short, use alternate hole
at out-
board bracket.
If sensor is too long, move collar toward rod end of
sensor.
Note holes and collar position with a marker.
Note: Sensor will tilt up slight from inboard to outboard.
FigureSpacer:
Figure 79
Deere ILS Components
29202
51
55
3
54
5
62
64
58
63
6
8
61
4
9
51
55
a
a
54
c
54
FigureSpacer:
Figure 80
Deere ILS Installation, Inboard
29206
a
51
62
55
58
51
58
5
8
9