Great Plains TCN5313 Operator Manual - Manual (Page 47)

Great Plains Manufacturing, Inc. Operating Instructions 43
03/17/2014 566-170M
Storage
Store the implement where children do not play. If possi-
ble, store inside for longer life.
1. Raise, fold and lock implement (page 28 and
page 25). For unfolded storage, see steps at right.
2. Perform Parking checklist (page 42).
3. If equipped with optional air/hydraulic brake system,
drain water from reservoir (page 48).
4. Lubricate the implement at all points listed under
“Lubrication and Scheduled Maintenance” on
page 48.
5. Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
6. Check all moving parts for wear or damage. Make
notes of any parts needing repair or replacement
before the next season.
7. Lubricate all points listed in Maintenance to prevent
rust.
8. Clean Turbo-Chisel of mud, dirt, excess oil and
grease.
9. Grease exposed cylinder rods to prevent rust.
10. Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.
Unfolded Storage
See page 28 for details on maintenance lock.
1a. Raise implement.
1b. IVerify the transport locks are in the transport posi-
tion.
1c. Be sure hydraulics are depressurized. Adjust locking
valves to the open position. Unfold wings until wing
is resting on shims.
1d. Lower implement onto lock channels.
1e. Set all hydraulic remotes to Float.