Great Plains TCN5313 Operator Manual - Manual (Page 28)

566-170M 03/17/2014
24 TCN5107-5313 Great Plains Manufacturing, Inc.
Operating Instructions
This section covers general operating procedures. Expe-
rience, machine familiarity, and the following information
will lead to efficient operation and good working habits.
Always operate farm machinery with safety in mind.
Pre-Start Checklist
Perform the following steps before transporting the
TCN5107-5313 Turbo-Chisel to the field.
❑ Carefully read “Important Safety Information” on
page 5.
❑ Lubricate Turbo-Chisel as indicated under “Lubrica-
tion and Scheduled Maintenance” on page 48.
❑ Check all tires for proper inflation, “Tire Inflation
Chart” on page 61.
❑ Check all bolts, pins, and fasteners. Torque as shown
in “Torque Values Chart” on page 63.
❑ Check Turbo-Chisel for worn or damaged parts.
Repair or replace parts before going to the field.
❑ Check hydraulic hoses, fittings, and cylinders for
leaks. Repair or replace before going to the field.
High Pressure Fluid Hazard:
Relieve pressure and shut down tractor before connecting, dis-
connecting or checking hydraulic lines. Use a piece of paper
or cardboard, NOT BODY PARTS, to check for leaks. Wear
protective gloves and safety glasses or goggles when working
with hydraulic systems. Escaping fluid under pressure can
have sufficient pressure to penetrate the skin causing serious
injury. If an accident occurs, seek immediate medical assis-
tance from a physician familiar with this type of injury.