Great Plains TCN5313 Operator Manual - Manual (Page 24)

20 TCN5107-5313 Great Plains Manufacturing, Inc.
566-170M 03/17/2014
Refer to Figure 5
4.
Rear jack should be lowered to ground when
machine is in parking position to keep machine from
tipping over backwards. Adjust rear jack up off
ground to allow for front jack
to be adjusted.
5. Use front jack to raise and lower turbo-chisel
tongue.
6. Remove hitch pin from tractor draw-bar.
7. Back tractor draw-bar into alignment with hitch . Set
tractor parking break.
8. Secure with a locking hitch pin.
9. Secure safety chain to an anchor on the tractor .
Refer to Figure 6
10. Retract jack foot.
11. After hitching tractor to turbo-chisel, store front jack
on storage stob on Turbo-Chisel tongue.
12. Remove pin from rear jack (Figure 5), move to front
outside tube of center frame storage stob (Figure 6)
and re-install pin.
13. Remove pin in jack stand tube (Figure 5) and raise
tube up to top hole, re-install pin.
Electrical Hookup
Refer to Figure 7
Make sure tractor is shut down with accessory power off
before making connections.
14. Mate lighting connector to tractor outlet.
15. Mate any optional or after-market electrical connec-
tors.
16. Make connections prior to TCN5107-5313 move-
ment.
4
Figure 5
Front & Rear Jack (Parking)
41993
42162
1
3
2
6
1
2
2
3
4
1
Figure 6
Jacks in Storage
42178
2
5
1
6
Figure 7
Lighting Connector European
(North American)
41995
36051