Great Plains TCN5313 Operator Manual - Manual (Page 30)

26 TCN5107-5313 Great Plains Manufacturing, Inc.
566-170M 03/17/2014
Folding
Fold the Turbo-Chisel for moves between fields, transport
over public roads, parking and storage.
Refer to Figure 15
Fold: Move to Level Ground
1.
Move the implement to level ground with adequate
overhead and lateral clearances for the fold
operation. Park the tractor.
2. Ensure locking valves on both fold cylinders are
open (parallel with side of cylinder), as shown.
Refer to Figure 16
Fold: Raise Implement (page 30)
3.
Extend the lift cylinders to full raise implement. Hold
at raised for a few seconds. Set circuit to Neutral.
Do not install transport locks.
Fold: Fold Wings (page 26)
4.
Activate the circuit to retract the fold cylinders.
Note: One wing may reach the stop before the other. A
slight asymmetry is not uncommon in folding.
5. When both wings are in contact with their stops. Set
fold circuit to Neutral (not Float) to hold at folded.
Fold: Close Locking Valves (page 26)
Refer to Figure 17
6.
At each wing, ensure the lock valves are in the
closed position (90 degrees from side of cylinder )
as shown.
2
1
Figure 15
Wing Lock Valve (Open)
42169
1 2
Figure 16
Wing Fold Progression
42174
Figure 17
Wing Lock Valve (Closed)
42170
2
1
1
2