Safety decals, Safety reflectors and decals, Reflector: slow moving vehicle (smv) – Great Plains NP4000 40-foot Operator Manual User Manual
Page 11: 055c, Reflectors: red, 266c, Reflectors: amber, 265c
Great Plains Manufacturing, Inc.
Important Safety Information
7
2012-03-28
407-776M
Safety Decals
Safety Reflectors and Decals
Your implement comes equipped with all lights, safety
reflectors and decals in place. They were designed to
help you safely operate your implement.
▲ Read and follow decal directions.
▲ Keep lights in operating condition.
▲ Keep all safety decals clean and legible.
▲ Replace all damaged or missing decals. Order new decals
from your Great Plains dealer. Refer to this section for
proper decal placement.
▲ When ordering new parts or components, also request
corresponding safety decals.
To install new decals:
1.
Clean the area on which the decal is to be placed.
2.
Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
Reflector: Slow Moving Vehicle (SMV)
On a post at rear of lift assist pivot weldment;
1 total
Reflectors: Red
On rear face of caster weldments, above daytime
reflectors, and on rear face of inner wing weldments near
pivot and inside daytime reflectors;
4 total
Reflectors: Amber
On outside faces of caster weldments, and on front faces
of outside tank cradles (on tankless models, the forward
reflectors are on the side faces of the front subframe);
4 total
818-055C
32339
838-266C
32339
838-265C
32339