Great Plains 3N4010HDA Operator Manual - Manual (Page 18)

196-444M Table of Contents Index 2013-09-24
14 3N-4010HDA Table of Contents Index Great Plains Manufacturing, Inc.
Preparation and Setup
This section helps you prepare your tractor and drill for
use. Before using the drill in the field, you must hitch the
drill to a suitable tractor and also setup the drill.
Pre-Setup Checklist
1. Read and understand “Important Safety Informa-
tion” on page 1.
2. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
3. Check that all grease fittings are in place and lubri-
cated. See “Lubrication” on page 64.
4. Check that all safety decals and reflectors are cor-
rectly located and legible. Replace if damaged. See
“Safety Reflectors and Decals” on page 6.
5. Inflate tires to pressure recommended and tighten
wheel bolts as specified. “Appendix” on page 74.
Hitching to Tractor
Crushing Hazard:
You may be severely injured or killed by being crushed
between the tractor and drill. Do not stand or place any part of
your body between machines being hitched. Stop tractor
engine and set park brake before installing hitch pin.
Choose a drill-hitch option (page 71) that is compatible
with your tractor drawbar.
The 3N-4010HDA has three hitch options:
• a clevis hitch,
• a small-hole, single-strap hitch or;
• a large-hole, single-strap hitch.
Always use a locking-style hitch pin sized to match the
holes in the hitch and drawbar, and at least 1
1 ⁄
2
in (3.8cm)
in diameter.
Figure 4
Hitch Options
27061