Great Plains TSF1290 Operator Manual - Manual (Page 46)

42 TSF1080, TSF1090, TSF1280 & TSF1290 Great Plains Manufacturing, Inc.
500-641M 05/10/2012
Filling Tanks
Always fill the hand wash tank first.
Filling Hand Wash Tank
Use only potable or distilled water in the hand wash tank. In
the event of a chemical accident, it may be necessary to spray
this water into your eyes.
Keep the hand wash tank clean, and free of mold and fungus.
After a period of storage, scrub the inside using a mild deter-
gent. Rinse thoroughly.
Plug or cap the hose when parked or stored, to prevent pests
from entering, nesting and plugging the hose. Test the valve
and hose when filling.
To fill the hand wash tank:
Refer to Figure 30
1.
Open the filler cap and inspect the condition of the
tank interior. If any debris, sediments, deposits or
growths are seen, scrub and rinse the tank before
use.
2. Unplug/uncap the hose and open the valve .
3. Begin adding clean water at the filler.
If water flows freely out the hose, close the valve.
if water does not flow freely out the hose, stop add-
ing water, and clear the obstruction.
4. Close the valve and complete filling the tank.
Figure 30
Hand Wash Tank Fill
27268
1
2
1
2