Great Plains 3PYPA Operator Manual - Manual (Page 24)

20 3PYPA Table of Contents Index Great Plains Manufacturing, Inc.
401-647M Table of Contents Index 03/20/2012
Raise Parking Stands
Refer to Figure 10
1.
If not already at minimum length, remove lower
pin
of parking stand, fully retract the inner leg ,
and re-insert pin.
2. Remove upper (holding) pin of parking stand (at
bottom of hinge bracket)
Refer to Figure 11
Crushing or Impact Injury Hazard:
Do not stand directly in front of the stand while raising it. You
need to have one hand free to insert the pin, and if you lose
your grip on the stand, it can swing down and inflict injury.
3. Swing the parking stand forward and up until it is
above the rear hole. Place the holding pin
in the
rear-most top hole of the hinge plate. This is the
parking stand position for transport and field opera-
tion.
4. If 3PYPA planter is equipped with row cleaners, the
stand may not be able to get fully vertical. It may be
necessary to use front top hole
.
Null4.aac:
Null4:
Figure 10
Raising Parking Stand
25240
1
2
3
4
1 2
3
1
4
5
Null4:
Figure 11
Parking Stand Raised
25241
5
4