Great Plains 3PYPA Operator Manual - Manual (Page 17)

03/20/2012 Table of Contents Index 401-647M
Great Plains Manufacturing, Inc. Table of Contents Index 13
Preparation and Setup
This section helps you prepare your tractor and 3PYPA
Planter for use, and covers tasks that need to be done
seasonally, or when the tractor/planter configuration
changes.
Before using the planter in the field, you must hitch it to a
suitable tractor, inspect systems and level the planter.
Before using the planter for the first time, and periodically
thereafter, certain adjustments and calibrations are
required.
Initial Setup
See “Appendix B - Initial and Option Setup” on
page 159 for pre-delivery items (normally completed by
dealer), and first-time/infrequent setup tasks, including:
• Install seed monitor console in tractor (page 159).
• Set initial down-pressure (option, page 165).
• Install Options not factory- or dealer-installed.
Post-Delivery/Seasonal Setup
On initial delivery, use with a new tractor, and seasonally,
check and as necessary, complete these items before
continuing to the routine setup items:
• Install seed monitor console in tractor (page 159).
• Bleed hydraulic system (page 113).
• Check center section and wing level (page 162).
• Radar calibration (page 161).
• De-grease exposed cylinder rods if so protected at last
storage.
Pre-Planting Setup
Complete this checklist before routine setup:
❑ Read and understand “Important Safety Informa-
tion” on page 1.
❑ Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
❑ Check that all grease fittings are in place and lubri-
cated. See “Lubrication” on page 124.
❑ Check that all safety decals and reflectors are cor-
rectly located and legible. Replace if damaged. See
“Safety Decals” on page 5.
❑ Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation Chart”
on page 139.