Gh j – ClearOne PAN6400 User Manual
Page 27
Configuring Standalone Installations
3-9
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
shown in Figure 3-6. For more detail on the ports on the rear panel of the Panorama,
see
Figure 3-6
Cascaded installation: S-Video and coaxial audio
To make the connections for a standalone, cascaded, S-Video installation, complete the
following steps:
1.
Ensure power is off to all devices.
2.
Connect the S-Video cable (provided with the source) from the source to the
S-Video adapter (provided) and connect the blue (Pb) and red (Pr) RCA
connections to the PAN6400 VDC (1) video input connections.
3.
Connect a set of RCA video cables from the video output connections on the
PAN6400 VDC (1) to the respectively colored input ports for that source on the
PAN6400 VDC (2).
This distributes the video to more than six zones.
4.
Connect the coaxial digital (S/PDIF) cable from the source to the PAN6400 VDC
IN port (green) for that source on the PAN6400 VDC (1).
5.
Connect another coaxial digital (S/PDIF) cable from the green output port on the
PAN6400 VDC (1) to the green input port for that source on the PAN6400
VDC (2).
6.
Connect an IR Emitter to the PAN6400 VDC (1) IR OUTPUT port for the source
and place the emitter end over the IR window on the front of the source.
7.
Connect a 3.5 mm jack cable from the PAN6400 VDC (1) IR INPUT for the source
to the PAN6400 VDC (2) IR OUTPUT for the source.
Legend
IR Emitter
CAT5
S-Video
Coaxial audio
Speaker
Display
Display
A/V Receiver
A/V Receiver
Zones 7-12
Zones 1-6
Source
PAN6400
VDC (1)
PAN6400
VDC (2)
w
e
r
t
y
u
i
o
a
s
d
f
g
h
j
5.1 or 7.1 channel
speaker outputs
5.1 or 7.1 channel
speaker outputs
IR Emitter
g
h
j
PANVP700
PANVP700
IR Emitter
IR Emitter
IR Receiver
IR Receiver