SARGENT Keypad Exit Devices - Manual (Page 16)

Copyright © 2006, 2008, Sargent Manufacturing Company
, an A
SSA ABL
O
Y Group company
. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
800-810-WIRE (9473) • www.sargentlock.com • A7137B
Outside
of door
1
2
3
4
5
6
7
8
9
0
*
#
Keypad
connector
Back
plate
Small
connector
from ET
Control
• Securely fasten top of
inside Escutcheon to
top of keypad using a
#8-32 x 1-1/2" machine screw
• Securely fasten
bottom of Escutcheon
(52-0086) to door using
#8 x 1" screw
Inside
of door
Outside
of door
Inside
of door
Outside
of door
Inside
of door
1
2
3
4
5
6
7
8
9
0
*
#
#8-32 x 1-1/2’’
Flat head
machine
screw
#8 x 1’’
Screw
Inside
Escutcheon
Keypad
52-0086
Bracket
Step #5 Inside Controller Assembly
• Plug Keypad connector into
inside Escutcheon as shown.
The back plate can be removed
to feed the large connector
through slot into the circuit
board to be assured of proper
fit. If connector is not fully
and properly seated on
pins, unit will not
function properly
• Plug smaller connector as
shown into inside Escutcheon
NOTE: Both connectors
go on only one way. Do
not offset the connectors.
Be sure connectors are
seated completely.
14
Mortise Installation Instructions for
KP8900 Series (Continued)
4