Winchester Repeating Arms X Pump (SXP) - Manual (Page 17)

r emovinG the t hree -s hot A DApter (p luG )
1. Unscrew the magazine cap and remove it.
2. The magazine three-shot adapter is located
underneath the magazine spring retainer and is
under pressure from the magazine spring. Using your
index finger or a large blade-type screwdriver, press
the magazine spring retainer into the magazine
approximately 1" and rotate it ¼ turn (Figure 7).
3. The magazine spring retainer is under pressure
from the magazine spring. Keep the magazine spring
under control and carefully remove the magazine
spring retainer (Figure 8). Remove the magazine
three-shot adapter (plug) and replace the magazine
spring retainer.
4. Align the full-length grooves in the magazine spring
retainer with the protrusions inside the magazine
tube, found at the six and nine o'clock positions.
5. Compress the magazine spring back into the
magazine tube.
6. Replace the magazine spring retainer by pushing it
into the magazine tube approximately 1" and rotating
it ¼ turn to lock it in place. Make sure the magazine
spring retainer is locked into place.
7. Install the magazine cap.
15
FIGURE 8
Maintain control of the
magazine spring as you
remove the magazine
spring retainer.
FIGURE 7
Push down on the
magazine spring retainer
and rotate it ¼ turn.