Tweco 2460 Heavy Duty CC CV Control Wire Feeder - Manual (Page 46)

3. To install the Wire Reel Kit (870059):
a. Mount the shaft (6) in the upper hole of the
support (1) to assure proper clearance for the wire
reel (7). See Figure 4.
b. Mount the wire reel (7) on the shaft (6).
c. Install the wire reel washer, the steel wire reel
washer, compression spring, “T” wire reel washer,
and the drag adjusting screw.
d. Loosen the wing nuts holding the movable
arms. Rotate the arms inward towards the center of
the reel (7). Place the coiled wire on the reel so the
wire feeds from the bottom of the coil to the wire
feeder. See Figure 5.
e. Reposition the movable arms outward and
tighten the wing nuts.
f. Tighten the drag adjusting screw until the
desired reel drag is achieved.
Figure 4
Figure 5
I-169
2 December 1, 1997 Revised