Tweco 2460 Heavy Duty CC CV Control Wire Feeder - Manual (Page 33)

Installing Feed Rolls and Guides — Feed Rolls,
Input Guides, and Output Guides are supplied in
Feed Roll Kit 375980-X, depending upon wire size,
type, and Feed Roll style. Follow the procedure
below for initial installation or changing Feed Rolls
and/or guides for different wire size or type. See
Figure 2 for reference to components below.
NOTE: When Feedhead assembly is
shipped from factory, the Feed Roll
Screws (quantity of 12) are placed sepa-
rately in a cloth bag and furnished with
the Feedhead assembly.
Feed Rolls
1. Locate and open the cloth bag with twelve
feedhead screws (#8-32 x 1" allen socket-head
screws).
2. Select proper Feed Rolls and Guides. See
375980 and determine the proper dash (–) number
for wire type, Feed Roll style, Feed Roll part num-
bers, Input Guide, Center Guide, and Output Guide
part numbers.
3. Loosen the Pressure Arm Knobs and lift the
Pressure Arm off.
4. Install Center Guide in place before installing
both bottom Feed Rolls. See Figure 2.
NOTE: The Center Guide may be in-
stalled if only one, but not both lower
Feed Rolls are in place.
5. Install the two lower Feed Rolls onto the Idler
Gears. See Figure 4. Insert three Feed Roll screws
in each roll and tighten.
Figure 3
Figure 4
TIP-219
FEEDHEAD ASSEMBLY NO. 376799A-1, -2, -3, -4
December 1, 1997 Revised Page 3