Tweco 2460 Heavy Duty CC CV Control Wire Feeder - Manual (Page 4)

April14, 2005 Revised 1-1
430429-249
INTRODUCTION
INTRODUCTION
How To Use This Manual
This Owner’s Manual usually applies to just the under-
lined specification or part numbers listed on the cover. If
none are underlined, they are all covered by this manual.
To ensure safe operation, read the entire manual, includ-
ing the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING,
CAUTION
, and NOTE may appear. Pay particular atten-
tion to the information provided under these headings.
These special headings are easily recognized as
follows:
WARNING
A WARNING gives information regarding
possible personal injury.
CAUTION
A CAUTION refers to possible equipment damage.
NOTE
A NOTE offers helpful information concerning cer-
tain operating procedures.
Additional copies of this manual may be purchased by
contacting Thermal Arc at the address and phone number
given in the next section. Include the Owner’s Manual
number and equipment identification numbers.
Electronic copies of this manual can also be downloaded
at no charge in Acrobat PDF format by going to the Ther-
mal Arc web site listed below and clicking on the Litera-
ture Library link:
http://www.thermadyne.com/tai
Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear on a
nameplate attached to the control panel. In some cases,
the nameplate may be attached to the rear panel. Equip-
ment which does not have a control panel such as gun
and cable assemblies is identified only by the specifica-
tion or part number printed on the shipping container.
Record these numbers for future reference.
Receipt Of Equipment
When you receive the equipment, check it against the in-
voice to make sure it is complete and inspect the equip-
ment for possible damage due to shipping. If there is any
damage, notify the carrier immediately to file a claim. Fur-
nish complete information concerning damage claims or
shipping errors to:
Thermadyne, Inc.
Thermal Arc Order Department
82 Benning Street
West Lebanon, New Hampshire, USA 03784
For more information, call (603) 298-5711.
Include all equipment identification numbers as described
above along with a full description of the parts in error.
Move the equipment to the installation site before uncrating
the unit. Use care to avoid damaging the equipment when
using bars, hammers, etc., to uncrate the unit.