Tweco 200 XT Auto-Cut 380V - Manual (Page 61)

AUTO-CUT 200 XT
Manual 0-5253 OPERATION 4-13
Code Message Remedy / Comments
249
Inverter 2A Circuit
Fault
Inverter Module 2 Section A detected a circuit fault; Damaged Inverter Module 2
250 Not used Reserved for other models with additional inverter sections.
251 Not used Reserved for other models with additional inverter sections.
252 Not used Reserved for other models with additional inverter sections.
253
Inverter 1A Over
Temp
Inverter Module 1 Section A detected an over temperature fault; Check for restricted air flow,
clogged radiator; Defective fan; If problem persists replace inverter module.
254
Inverter 1B Over
Temp
Inverter Module 1 Section B detected an over temperature fault; Check for restricted air flow,
clogged radiator; Defective fan; If problem persists replace inverter module.
255
Inverter 2A Over
Temp
Inverter Module 2 Section A detected an over temperature fault; Check for restricted air flow,
clogged radiator; Defective fan; If problem persists replace inverter module.
256 Not used Reserved for other models with additional inverter sections.
257 Not used Reserved for other models with additional inverter sections.
258 Not used Reserved for other models with additional inverter sections.
259
Inverter 1A Over
Temp Ambient
Inverter circuitry is over temperature likely cause is ambient greater than 40 deg C; Reduce
power supply cutting Duty Cycle; Reduce ambient air temperature; Add auxiliary cooler.
260
Inverter 1B Over
Temp Ambient
Inverter circuitry is over temperature likely cause is ambient greater than 40 deg C; Reduce
power supply cutting Duty Cycle; Reduce ambient air temperature; Add auxiliary cooler.
261
Inverter 2A Over
Temp Ambient
Inverter circuitry is over temperature likely cause is ambient greater than 40 deg C; Reduce
power supply cutting Duty Cycle; Reduce ambient air temperature; Add auxiliary cooler.
262 Not used Reserved for other models with additional inverter sections.
263 Not used Reserved for other models with additional inverter sections.
264 Not used Reserved for other models with additional inverter sections.
265
Inverter 1A No Input
Power
Inverter section may have no input power. Contactor not closed; Defective contactor or CB4
tripped; Inverter section input not connected; Defective Inverter.
266
Inverter 1B No Input
Power
Inverter section may have no input power. Contactor not closed; Defective contactor or CB4
tripped; Inverter section input not connected; Defective Inverter.
267
Inverter 2A No Input
Power
Inverter section may have no input power. Contactor not closed; Defective contactor or CB4
tripped; Inverter section input not connected; Defective Inverter.
268 Not used Reserved for other models with additional inverter sections.
269 Not used Reserved for other models with additional inverter sections.
270 Not used Reserved for other models with additional inverter sections.
271
Inverter ID reading
fault
CCM found ID values inconsistant during reading. CCM to an Inverter section ribbon dam-
aged or disconnected; Inproper ribbon cable routing.