Tweco 200 XT Auto-Cut 380V - Manual (Page 28)

AUTO-CUT 200 XT
3-� INSTALLATION Manual 0-5253
3.04 Position the Power Supply
WARNINGS
Do not touch live electrical parts.
Disconnect input power conductors from de-energized supply line before moving unit.
FALLING EQUIPMENT can cause serious personal injury and equipment damage.
Use the lifting eye when using straps to lift the power supply.
Use a forklift, crane, or hoist to lift the unit off the shipping pallet as shown. Keep the power supply steady and
vertical . Do not lift it any further than necessary to clear the shipping pallet.
Art # A-11503
Set the power supply on a solid, level surface. The installer may fasten the power supply to the floor or a support-
ing fixture with hardware passing through the horizontal parts of the power supply feet.