Tweco CutMaster 35mm 40mm User Manual

Page 3

WARNING

Read and understand this entire Manual and your employer’s safety practices before install-

ing, operating, or servicing the equipment.

While the information contained in this Manual represents the Manufacturer's best judge-

ment, the Manufacturer assumes no liability for its use.

Plasma Cutting Power Supply

CutMaster™ 35mm

SL60 1 Torch™ Operating Manual No.: 0-5118

CutMaster™ 40mm

SL60 1 Torch™ Operating Manual No.: 0-5118

Published by:

Thermal Dynamics Corporation

82 Benning Street

West Lebanon, New Hampshire, USA 03784

(603) 298-5711

www.thermal-dynamics.com

Thermadyne Corporation

Reproduction of this work, in whole or in part, without written permission of the publisher is

prohibited.

The publisher does not assume and hereby disclaims any liability to any party for any loss or

damage caused by any error or omission in this Manual, whether such error results from negli-

gence, accident, or any other cause.

Original Publication Date: October 30, 2008

Revision Date: April 25, 2012

Record the following information for Warranty purposes:

Where Purchased:_________________________________________________

Purchase Date:__________________________________ __________________

Power Supply Serial #:___________________________ ___________________

Torch Serial #:_____________________________________________________