Tweco CutMaster 35mm 40mm - Manual (Page 15)

CUTMASTER 35mm, 40mm
Manual 0-5118 2-1 INTRODUCTION
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Owner’s Manual applies to just
specification or part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
CAUTION , and NOTE may appear. Pay
particular attention to the information provided
under these headings. These special annotations
are easily recognized as
follows:
NOTE
An operation, procedure, or background infor-
mation which requires additional emphasis or
is helpful in efficient operation of the system.
CAUTION
A procedure which, if not properly followed,
may cause damage to the equipment.
!
WARNING
A procedure which, if not properly followed,
may cause injury to the operator or others in
the operating area.
WARNING
Gives information regarding possible electrical
shock injury. Warnings will be enclosed in a box
such as this.
Additional copies of this manual may be
purchased by contacting Thermadyne at the
address and phone number in your area listed
in the inside back cover of this manual. Include
the Owner’s Manual number and equipment
identification numbers.
Electronic copies of this manual can also be
downloaded at no charge in Acrobat PDF format
by going to the
Thermal Dynamics web site listed below and
clicking on Thermal Dynamics and then on the
Literature link:
http://www.thermal-dynamics.com
2.02 Equipment Identification
The unit’s identification number (specification
or part number), model, and serial number
usually appear on a data tag attached to the
rear panel. Equipment which does not have
a data tag such as torch and cable assemblies
are identified only by the specification or part
number printed on loosely attached card or the
shipping container. Record these numbers on the
bottom of page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it
against the invoice to make sure it is complete
and inspect the equipment for possible damage
due to shipping. If there is any damage, notify
the carrier immediately to file a claim. Furnish
complete information concerning damage claims
or shipping errors to the location in your area
listed in the inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of
the parts in error.
Move the equipment to the installation site
before un-crating the unit. Use care to avoid
damaging the equipment when using bars,
hammers, etc., to un-crate the unit.