Soleus GPS Sole (SG007) - Manual - Manual (Page 8)

RDY13
6.4) Using HRM mode:
HRM mode and RUN mode has the same CHRONO counter. When the chronograph is
started or stopped in RUN mode, the same thing happens in HRM mode. They just differ in
the views. This mode is dedicated to HRM views
You have to Link your HRM belt first. Go to SET mode/ HRM LINK mode. After the HRM is
linked, you can turn ON or OFF the HRM connection by press & holding S5 for 2-3 seconds
in any mode. The Watch will display HRM ON or OFF and then go back to previous screen. If
HRM is OFF, you will not be able to receive HRM signals from the HRM belt and the watch
will display “
- - “.
6.4.1) Press S7 from TIMER mode to HRM mode.
a. If GPS is initially OFF, the watch will automatically search for GPS signal. IT
will then display the remaining battery level, remaining Track memory, and
then GPS GO start screen (if Satellite signal already received) or INDOOR
start screen ( if no GPS signal received).
b. If GPS is already ON, press S5the watch will go directly to GPS GO start
screen.
6.4.2) Press S1 to START / STOP.
6.4.3) Press S11 to take manual Lap. The Lap number/ Lap time, & Split Time will
display for 10 seconds and then continue running.
6.4.4) If AUTO LAP is turned ON in SET mode, the watch will take Laps based on the
setting.
6.4.5) Press S5 to change views in line 2. You can select either PACE, Speed, HRM,
Calorie, Clock, Chrono, or Distance to display in Line 2.
6.4.6) While Chrono is running, line 1 will display the current HR value. Line 3 will
display the Chrono.
6.4.7) While the chrono is stopped, Press and hold S1 or just press S11 to save the
data. The watch will display the saved file number and go back to GPS GO (with
GPS signal) or INDOOR (no GPS signal) start screen.
HRM setting in HRM mode: You can LINK your HRM belt or set the HR zone, High and Low
limits, and Zone Alarm ON/OFF in this mode.
Press and hold S11 in HRM mode to enter HRM SET mode. HRM LINK will start to
blink.
Press S1/ S11 to toggle between SET HRM and SET LINK HRM.
Press S7 to exit
LINK HRM:
Press S5 while LINK HRM is blinking. The watch will display LINK HRM with a
scrolling bar at the top (1 st line). Properly wear your HRM belt on your chest.
Within 1 minute, it will display your heart rate and the ID and then go to HRM
screen. After 2-3 seconds, it will go to GPS/INDOOR screen then press S5 (see
below function flow or watch actual operation).
If after 1 minute the watch cannot receive the HRM signal, it will display “ FAIL
HRM” and go to “LINK HRM SET” screen.
GPS Sole