Soleus GPS Sole (SG007) - Manual - Manual (Page 7)

RDY13
6.3.2) Press S1 to START / STOP / RESTART.
6.3.3) Press S11 to take manual Lap. The Lap number/ Lap time, & Split Time will
display for 10 seconds and then continue running.
6.3.4) While the chronograph is stopped, Press and hold S1 or just press S11 to save
the data. The watch will display the saved file number and go back to GPS GO
(with GPS signal) or INDOOR (no GPS signal) start screen.
6.3.5) Press S5 to change views in Line 2. You can select either PACE, Speed, HRM,
Calorie, Clock, Chrono, or Distance to display in Line 2.
6.3.6) Line 1 will display the countdown Timer. Line 3 will display the distance.
6.3.7) When the segment timer reaches zero, Line 1 will blink. Line 2 will display the
Distance; Line 3 will display the Segment # and Loop number.
6.3.8) The timer will auto loop for 50 times and auto stop.
TIMER setting mode:
You can set the timers in the TIMER mode. Follow the steps below:
Press and hold S11 and the watch will display HOLD TO SET. The segment number
will start to blink.
Press S1/S11 to change the number
Press S5 to set the HOUR. The hour digit starts to blink.
Press S1/S11 to change the digits
Press S5 to set the MINUTE. The minute digit starts to blink.
Press S1/S11 to change the digits
Press S5 to set the SECONDS. The second’s digit starts to blink.
Press S1/S11 to change the digits
Press S7 to exit.
GPS Sole