Soleus GPS Sole (SG007) - Manual - Manual (Page 10)

RDY13
Watch reset operation
Press the 4 buttons at the same or when you change the battery will reset the watch.
The watch will display the following screens at 2 seconds interval: display all, two’s (with
light ON), fives (with beep sound), all digits, software code, and go to TIME mode.
TIME mode
Press S7 from SET mode to TIME mode. The watch will display TIME and then display
time 1.
Pres S1/ S7 will go to RUN mode.
Press and hold S7 for 2 seconds 2 will turn ON or OFF the GPS. The watch will
display GPS OFF and go back to previous screen.
Press & hold S5 for 2-3 seconds will turn ON or OFF the HRM function. The watch will
display HRM ON or OFF and then go back to previous screen.
Viewing Time 1/ Time 2 in TIME mode:
Press & hold S1 to change Time 2 from Time 1. T2 will start to blink and then change
to time 2.
Same procedure to change from Time 2 to Time 1.
Time 1 will not display T1 or the City code. Only Time 2 will display T2 or the City code.
TIME / NIGHT / CONTRAST / CHIME setting in Time mode:
From any views of TIME mode, press and hold S11 until the “TIME” blinks.
Press S1 or S11 to select any of the sub views: TIME, NIGHT, CONTRAST and
CHIME setting.
Press S5 to enter selected sub-views.
Press S1 or S11 to change the value.
Press S7 to exit setting.
TIME 1/ TIME 2 setting in Time mode:
You have two options in setting the watch,
GPS or MANUAL. In manual setting, you can
manually set the time. If you select the GPS option, the watch will be automatically set
based on the data and time data from GPS satellites.
Press S5 while TIME is blinking.
Press S1/S11 for Time 1 or Time 2 setting
Press S5 to select T1 or T2. GPS or MANUAL will blink.
Press S1/S11 to select between GPS or MANUAL
Press S5 to confirm selection.
GPS Sole