Soleus GPS Sole (SG007) - Manual - Manual (Page 3)

RDY13
4.4) How to turn OFF the GPS:
• In TIME mode, Press and hold S7 and the watch will display GPS OFF, and then go
back to TIME mode.
• Press & hold S7 while GPS is initially ON, the watch will display GPS OFF. The
GPS will be turned OFF and the watch will go back to previous screen.
GPS signal and its meaning:
You will hear a beep sound when the watch received a GPS signal or when the
GPS signal has been lost. LOST GPS SIGNAL will also be displayed in the
screen.
If no Satellite signal is received within 15 minutes, the watch will auto return to
Time mode.
When CHRONO is stopped or reset, if no key operation after 15 minutes, it will
automatically return to Time mode. GPS will be on standby for the next 5 hours,
after that time, the GPS will be turned OFF.
Step 5) Pair your Heart Rate monitor:
The HRM belt is on standby and ready to send data to your watch. Wear the belt directly on
your skin just below your breastplate. It should be snug enough to stay in place during your
run.
5.1) Push one tab on the strap through the slot in the HRM transmitter.
5.2) Wet both electrodes with a damp cloth on the back of the HRM belt. This will help create
a strong electrical connection between your chest and the HRM transmitter.
5.3) Wrap around the chest belt around your rib cage just below the pectoral muscles and
attach the other end of the strap to the HRM transmitter. The elastic strap should be
adjusted so that it is snug enough so that it will not move during use but not so tight as to
restrict breathing.
5.4) Bring the GPS watch within range of the HRM transmitter.
5.5) Go to SET mode/ LINK HRM mode and link the HRM belt to the watch. The watch will
then automatically go to RUN mode. Your Heart rate information will now be displayed in
the watch (see below on how to link the HRM “ Setting HRM LINK”).
5.6) The HRM belt is now paired to your watch. The serial number is now saved in the
memory of the watch. If you turn OFF the HRM function, then turn ON again, the HRM
belt is still linked to the watch. There is no need to re-link the HRM belt.
5.7) You can turn ON or OFF the connection between the HRM belt and the watch by press &
hold S5 for 2-3 seconds. The watch will display HRM ON or OFF and then go back to
previous screen. If HRM is OFF, you cannot receive HRM data to the watch.
5.8) If the heart rate data does not appear on the watch, or if you have erratic data, follow the
tips below. If the problem persists, you may have to pair the HR belt again.
5.5.1) Make sure the HR belt is snugly fit to your body.
5.5.2) Reapply water or electrode gel to the electrode of the HR belt.
5.5.3) Clean the electrodes from possible contamination that may interfere with heart
rate signals.
5.5.4) Wear a cotton shirt or if possible, wet your cotton shirt. Synthetic fabric that rubs
with your skin may create static electricity and interfere with the heart rate
signal.
5.5.5) Move away from strong electromagnetic fields and other wireless sensors which
can interfere with your heart rate sensor. Possible sources of wireless
interference may include high voltage power lines, electric motors, microwave
ovens, cordless phones, and wireless LAN or access points.
GPS Sole