HCO BG30L Manual - Manual (Page 24)

4 – Camera Setup
- 22 -
I means Trigger Interval. 10: the minutes (0～59min). 30: the
seconds (0～59sec).
B means Photo Burst. 2: the numbers of the pictures taken after each
trigger (1 picture~9pictures).
M means Send Mode. 2: the function number (0: local. 1: MMS. 2:
e-mail;).
W means Work Day. 1110001: Each number represents a day at
the sequence of Sunday, Monday, Tuesday, Wednesday, Thursday, Friday,
and Saturday. 1 means Arm. 0 means Disarm.
T means Timer. OFF: Timer function off which means the PIR
sensor will work all the time.
T means Timer. ON10:20-16:30 means the PIR sensor will
work from 10:20 to 16:30.
D means Set Clock. This command can set clock use your current cell
phone time.
If success, you will receive a reply SMS: Interval 10:30, Burst 2, Work Day
1110001, Time Switch OFF, Date Time: 2011/8/2418:12:12, Active Zone:
0111111
If fails, you will receive a reply SMS: Command error! Please check again.
Note: #E# can’t be omitted when use this command to change any camera
settings.