HCO BG30L Manual - Manual (Page 16)

4 – Camera Setup
- 14 -
change to MasterNum=1234567890.
4.5 Set Normal Users
You can set at most 3 Normal Users. The Normal Users can be set by the
Master. There are two ways to set the Master Number:
Method 1:
Send SMS command:
Send #N#1234567891#1234567892#1234567893# to your camera’s SIM
card phone number. If success, you will receive a reply SMS:
http://mmsc.cingular.com, 066.209.11.32, 80, wap.cingular,,,
1234567890, 1234567891, 1234567892, 1234567893
If fail, you will receive a reply SMS: Command error! Please check again.
Method 2:
Editing the profile.txt:
After you open the profile.txt in a notepad, find the PhoneNumX= line and
change to PhoneNum2=1234567891, PhoneNum3=1234567892,
PhoneNum4=1234567893.
4.6 Set MMS Parameters
If you want get instant MMS images when the camera is triggered, you
should set the MMS parameters correctly.
Method 1:
Send SMS command:
Send #M#URL#IP#Port#APN#Account#Password# to your camera’s SIM
card phone number. The following chart shows the meaning of each field.
Please note that character # is between each field. Please don’t forget the
character “#” at the end of the command.