E-flite Piper Pawnee 15e ARF - Manual (Page 40)

40 E-flite Piper Pawnee ARF Assembly Manual
 11. Use a pin drill and 1/16-inch (1.5mm) drill bit
to drill four locations (two each side) for the cowl
mounting screws.
Note: Ensure the painted stripe on the cowl lines up with
the stripe on the fuselage before drilling.
 12. Use a pin drill and 1/8-inch (3mm) drill bit to drill
the four holes in the cowling for the mounting screws.
 13. Apply a few drops of thin CA to each of the
holes drilled in the previous step to harden the
surrounding wood.
 14. Secure the cowl to the fuselage using four
2mm x 8mm sheet metal screws. Secure the propeller
to the motor.