E-flite Piper Pawnee 15e ARF - Manual (Page 22)

22 E-flite Piper Pawnee ARF Assembly Manual
Joining the Wing Panels
Required Parts
Wing panel (right and left) Wing joiner (2)
Required Tools and Adhesives
30-minute epoxy Clamps
Mixing cup Mixing stick
Epoxy brush Low tack tape
Pencil Felt-tipped pen
Sandpaper Rubbing alcohol
Paper towels
 1. Mix approximately 1/2 oz (15 ml) of 30-minute
epoxy. Apply the epoxy to the mating sides of each
of the joiners.
 2. Use clamps or tape to hold the two joiners tightly
together until the epoxy fully cures.
 3. Use a felt-tipped pen to mark the wing panels and
joiner. This will help in installing the joiner in the same
orientation it was test fit in.