E-flite Piper Pawnee 15e ARF - Manual (Page 24)

24 E-flite Piper Pawnee ARF Assembly Manual
 7. Apply a coat of epoxy to the root rib of one of the
wing panels.
 8. Apply epoxy inside the joiner box of the wing panel.
 9. Slide the joiner into the wing panel and clean up any
excess epoxy using a paper towel and rubbing alcohol.
Use enough epoxy that is flows out of the joiner pocket
when the joiner is inserted. Repeat Steps 6 through 8 and
quickly proceed to the next step.
 10. Use a clamp at the front of the wing and low-tack
tape to hold the wing panels tightly together until the
epoxy fully cures.