E-flite Piper Pawnee 15e ARF User Manual

Page 13

E-flite Piper Pawnee ARF Assembly Manual



4. Use 6-minute epoxy to glue the servo mounting block

to the servo cover as shown. Allow the epoxy to fully cure

before proceeding.



5. Position the servo between the servo mounting

block. Use a pencil to mark the locations for the servo

mounting screws on the blocks. The servo should not

touch the cover to prevent it from absorbing vibrations

from the airframe.



6. Use a drill and 1/16-inch (1.5mm) drill bit to drill the

holes for the servo mounting screws.



7. Apply a few drops of thin CA to each of the

holes drilled in the previous step to harden the

surrounding wood.