E-flite Piper Pawnee 15e ARF - Manual (Page 16)

16 E-flite Piper Pawnee ARF Assembly Manual
 14. Use side cutters to remove the backplate from
a control horn. Attach the clevis to the outer hole
of the horn.
 15. Position the control horn so a) the holes in the
horn align with the hinge line and b) the pushrod is
90 degrees to the hinge line. Use a felt-tipped pen
to transfer the locations for the two mounting screws
onto the aileron.
 16. Use a drill and 5/64-inch (2mm) drill bit to drill the
two holes for the aileron control mounting screws.
 17. Apply a few drops of thin CA to each of the
holes drilled in the previous step to harden the
surrounding wood.