E-flite Piper Pawnee 15e ARF - Manual (Page 37)

37 E-flite Piper Pawnee ARF Assembly Manual
Motor Installation
Required Parts
Fuselage Motor w/mount and accessories
#4 washer (4) Cowling
Motor Battery
Electronic speed control Propeller
Plywood X mount spacer (2)
Hook and Loop straps (2)
2mm x 8mm sheet metal screw (4)
4-40 x 3/4-inch socket head screw (4)
Required Tools and Adhesives
Drill bit: 1/16-inch (1.5mm), 1/8-inch (3mm)
Threadlock Phillips screwdriver: #2
Card stock Low-tack tape
Pin drill
Ball driver: 3/32-inch
 1. Attach the X-Mount to the motor using the screws
provided with the motor and a #2 Phillips screwdriver.
Make sure to use threadlock on all four screws so they do
not vibrate loose.
 2. Attach the motor to the firewall using four
4-40 x 3/4-inch socket head screws and a 3/32-inch
ball driver. Place the (2) 3mm plywood X mount spacers
between the firewall and motor mount. Make sure to
use threadlock on the four screws to prevent them from
vibrating loose.
 3. Plug the motor wires into the speed control. Secure the
speed control to the bottom of the motor box using hook
and loop tape.