E-flite P-51B Mustang 32e ARF User Manual
Page 30
30
E-flite P-51B Mustang 32e ARF Assembly Manual
3. Slide the two wing panels together. They will fit
tightly against each other as shown.
You can either leave the wing panels where they
can be separated for transport or you may glue
them together using 12-minute epoxy. If you elect to
glue them together, a small piece of gray UltraCote
®
covering is included to cover the joint once this is done.
4. Connect the leads between the receiver and
wing. Make sure the retracts, flaps, ailerons and
any other connections are correct at this time.
5. Place the wing on the fuselage. Make sure
the leads are tucked in and not exposed between
the wing and fuselage. Use two nylon wing bolts
and a flat blade screwdriver to secure the wing
to the fuselage.
6. Slide the radiator scoop in position. The notch
in the scoop fits the tab on the wing. The scoop is
connected to the fuselage using a magnet.
7. Attach the cockpit hatch on the fuselage.
An important part of preparing the aircraft for flight is
properly balancing the model.
CAUTION: Do not inadvertently skip this step or
property damage and injury could occur.
8. The recommended Center of Gravity (CG)
location for your model is 3 to 3
1
/
2
inches (76 to
89mm) back from the leading edge of the wing
as shown with the battery pack installed. Mark the
location of the CG on the top of the wing with a
felt-tipped pen.