E-flite P-51B Mustang 32e ARF - Manual (Page 21)

21 E-flite P-51B Mustang 32e ARF Assembly Manual
 12. Use 2–3 drops of thin CA in each of the holes
for the aileron servo cover mounting screws. This
will harden the surrounding wood, which helps
prevent the screws from breaking the wood and
vibrating loose.
 13. While you have the thin CA in your hand,
apply 2–3 drops in each of the holes for the aileron
control horn mounting screws.
 14. Insert the Z-bend in the 2-inch (52mm) linkage
wire through the hole enlarged in Step 7.
 15. Use four 2mm x 8mm sheet metal screws with
shoulder and a #1 Phillips screwdriver to secure
the aileron servo cover to the wing. Use the mark
made in Step 1 to make sure the cover is oriented
correctly. Then remove the mark can using rubbing
alcohol and a paper towel.
 16. Use a hobby knife with a #11 blade to remove
the control horn backplate from the control horn.
Discard the backplate as it will not be used when
installing the control horn.
 17. Use a #1 Phillips screwdriver and two 2mm x
8mm sheet metal screws to attach the control horn
to the aileron.