E-flite P-51B Mustang 32e ARF - Manual (Page 25)

25 E-flite P-51B Mustang 32e ARF Assembly Manual
 15. Use four 2mm x 8mm sheet metal screws with
shoulder and a #1 Phillips screwdriver to secure the
flap servo cover to the wing. You can remove the
mark made earlier when the cover was removed
using rubbing alcohol and a paper towel.
 16. Set the flap switch (or knob) to the UP position.
Use the endpoint adjustment to align the flap with
the trailing edge of the wing. You will want to make
sure both flaps sit up without binding by adjusting
the clevis. This will help to ensure they throw the
same amount when going down.
 17. Set the flap switch (or knob) to the DOWN
position. Use the endpoint adjustment to set the
distance between the wing trailing edge and flap so
it measures 1 5 /
8
-inch (41mm).
 18. Repeat Steps 1 through 17 to install the
remaining aileron servo and linkage.
When installing the remaining flap servo, start with
the flap and flap servo in the UP position (using the
transmitter) to set the correct length for the linkage. This
will avoid stalling the servo if the linkage is too short.
 19. Remove the string from the flap and aileron
leads. Mark the flap lead using low-tack tape. Make
sure your radio system has been turned off as to not
run the batteries down.
Fixed Gear Installation
Required Parts
Wing panel (right and left)
Main gear strut (right and left)
Main gear wheel, 2
1 /
2
-inch (63mm) (2)
Main gear strut mount with setscrew (2)
Wheel collar with setscrew (4)
3mm x 8mm sheet metal screw (8)
Required Tools and Adhesives
Hex wrench: 1.5mm
Phillips screwdriver: #2
Threadlock
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
 1. Insert the main gear strut into the main gear strut
mount. Use a #2 Phillips screwdriver to tighten the
setscrew on the flat area of the main gear strut.
Assemble the right and left main gear at this time.
Note: The included fixed gear will differ slightly
from what is shown.