Default serial parameters, Aйс~мдн=péêá~ä=m~к~гйнйкл, K==oéãçíé=`зенкзд=mêçíçåçä – Barco MatrixPRO HD/SD-SDI User Manual
Page 70

60
MatrixPRO • 16x16 and 8x8 HD/SD-SDI Router • User’s Guide
_K==oÉãçíÉ=`зенкзд=mêçíçÅçä
Default Serial Parameters
aЙС~мдн=pÉêá~ä=m~к~гЙнЙкл
The following are the parameter settings for serial communication:
•
Baud Rate = 57600 baud
•
Parity = NONE
•
Stop Bit = 1
•
Data Bit = 8
•
Echo = ON
•
Flow Control = NONE
Note
These are defaults, which can be changed using serial
commands. In Chapter 3, refer to the “
” section for instructions.
This manual is related to the following products: