beautypg.com

Banner SureCross DX80 Wireless Networks User Manual

Page 7

background image

P/N 129232 rev. E

7

Banner Engineering Corp. • Minneapolis, MN U.S.A

www.bannerengineering.com • Tel: 763.544.3164

SureCross™ DX80K Wireless Configured

FlexPower™ Kit

It is Banner Engineering’s intent to fully comply with all national and regional regulations regarding radio frequency emissions. Customers who want to re-export this
product to a country other than that to which it was sold must ensure that the device is approved in the destination country. A list of approved countries appears in the
SureCross DX80 Wireless Product Manual, in the Agency Certifications section. Consult with Banner Engineering if the destination country is not on this list.

Certifications, Radio

900 MHz Models

FCC ID TGUDX80: This device complies with FCC Part 15, Subpart C, 15.247
IC: 7044A-DX8009

2.4 GHz Models

FCC ID UE300DX80-2400: This device complies with FCC Part 15, Subpart C, 15.247
ETSI/EN: In accordance with EN 300 328: V1.7.1 (2006-05)
IC: 7044A-DX8024

Environmental

Environmental Rating*

IEC IP67; NEMA 6

Operating Temperature**

−40 to +85° C (Electronics); −20 to +80° C (LCD)

Operating Humidity

95% max. relative (non-condensing)

Radiated Immunity

10 V/m, 80-2700 MHz (EN61000-6-2)

Shock and Vibration

IEC 68-2-6 and IEC 68-2-7
Shock: 30g, 11 millisecond half sine wave, 18 shocks
Vibration: 0.5 mm p-p, 10 to 60 Hz

* Please refer to the SureCross™ DX80 Wireless I/O Network product manual, Banner p/n 132607, for installation and waterproofing instructions.
** Operating the devices at the maximum operating conditions for extended periods can shorten the life of the device.

Outputs

Discrete Outputs

Two Sourcing

Discrete Output Rating

100 mA max current at 30V dc
ON-State Saturation: Less than 3V at 100 mA
OFF-state Leakage: Less than 10 µA

Discrete Output ON Condition

Supply minus 2V

Discrete Output OFF Condition

Less than 2V

Analog Outputs

Two, 0 to 20 mA

Maximum End-to-end Latency*

450 milliseconds

Output State Following Timeout

De-energized (OFF)

* From the sample point and with a good RF signal.