Metrohm 850 Professional IC Anion MSM-HC MCS Prep 1 - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
850 Professional IC – Anion MSM-HC – MCS – Prep 1
￭￭￭￭￭￭￭￭ 13
3 Installation
3.1 About this chapter
The Installation chapter contains
￭ this overview
￭ a brief set of instructions for the initial installation of the 850 Professio-
nal IC – Anion MSM-HC – MCS – Prep 1 (see Chapter 3.2, page 13).
At each step you will find cross-references to more detailed installation
instructions for individual components, should you require such aids.
￭ an installation diagram (see Chapter 3.3, page 16), showing a com-
pletely installed 850 Professional IC – Anion MSM-HC – MCS – Prep 1.
￭ several chapters (see chapter 3.4, page 23 and following) with
detailed installation instructions for all components, including those
that are already installed at the time the instrument is delivered.
3.2 Initial installation
Note
A number of the capillaries is already connected at the time the instru-
ment is delivered.
The following work steps must still be carried out:
Installing 850 Professional IC – Anion MSM-HC – MCS –
Prep 1
1 Setting up the instrument
(see Chapter 3.4, page 23).
2 Installations on the rear of the instrument
￭ Remove handle and rollers (see Chapter 3.6.1, page 26).
￭ Remove transport locking screws (see Chapter 3.6.3, page 31).
￭ Place the detector in the instrument and connect it (see Chapter
3.6.2, page 29).
￭ Connect the leak sensor (see Chapter 3.6.4, page 31).
￭ Connect drainage tubings (see Chapter 3.6.5, page 32).