Metrohm 817 Bioscan - Manual (Page 47)

3.2 Operation using «IC Net 2.1»
817 Bioscan
39
Method parameters
DC mode
The DC mode subtab of the Method parameters tab on the 817
Bioscan window is used to set the parameters for the DC
mode. This window is only available if Mode has been set to
DC on the Manual tab.
Method data
Cell potential Electric potential applied to the amperomet-
ric detector cell in V
Range:
-2 ... +2 V .
Oven Switches column oven on/off and sets op-
erating temperature.
Range:
15 ... 60 °C (> room temp. + 10 °C)
Range Selection of measuring range:
pA 10 ... 5000 pA .
nA 0.1 ... 50 nA .
µA 0.01 ... 5 µA .
Full scale The full-scale range (operating range) sets
the desired sensitivity for the analog output.
The possible values of the full-scale range
depend on the preset measuring
Range . For
RS232 data (IC Net 2.1), always the maxi-
mum settings should be used.