Metrohm 865 Dosimat plus - Manual (Page 51)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Parameters and dosing modes
865 Dosimat plus ￭￭￭￭￭￭￭￭ 41
Dosing ramp
The dosing ramp is a delay in the dosing rate at the time of the start of a
dosing step. It is advantageous primarily for manual titrations with indica-
tor, when small volume steps are to be dosed before the equivalence
point. The selectable delay time determines after which amount of time (in
seconds) the defined dosing rate is to be reached.
Range 0 ... 10 s
Default value 0 s
2 4 6 8 10 s
30
60
90
mL/min
Figure 17 Dosing ramp, two examples
6.1.4 Calculation
Menu ▶ Parameters ▶ Calculation
The calculation formula is predefined and cannot be edited.
Calculation formula
(Volume - Blank) × Titer × Conc. × Fac-
tor / (Sample size × Divisor)
where:
Volume Dosed volume
Blank Blank value
Titer Titer of the solution used
Conc. Concentration of the solution used
Factor Factor
Sample size Sample size. The sample size and the associated unit
can be entered under Menu
▶ Sample data. If a
balance is connected, then the sample size (with
unit) can also be accepted directly from the balance.
Divisor Divisor