DJI Z15-BMPCC - Manual (Page 25)

©2014 DJI. All Rights Reserved.
25
Zenmuse Z15-BMPCC User Manual
Trouble Shooting
NO. What Why How to
1
The gimbal keeps drifting
after initialization.
(1) The TX trims are too high.
(2) The GCU and Flight
Control System have been
disconnected.
(3) The gimbal mounting
direction is not pointing
towards the aircraft’s nose.
(1) Adjust the TX trims.
(2) Connect the GCU and Flight
Control System.
(3) Ensure the gimbal mounting
direction is the same with
aircraft’s nose.
2
The gimbal is abnormal after
initializing. Abnormal calibration after
manufacturing. Please contact the local dealer or
DJI customer service.
3
Cannot distinguish the
gimbal’s direction when in
use.
BVR (Beyond Visibility Range)
flight. Switch to the FPV Mode first, then to
another Working Mode as needed.
4
The gimbal LED is blinking
red.
(1) There is a disconnection
between the gimbal and
camera.
(2) Camera is off.
(3) Camera setup failure.
(1) Make sure the cables are
securely connected.
(2) Power on the camera.
(3) Set the HDMI resolution to 1080i.
5
The gimbal’s green or yellow
LED is solid on but no video
displayed.
(1) HDMI-HD/AV transmission
module is disconnected from
camera.
(2) The camera is power off.
(3) HD mode, DJI Lightbridge APP
video source has been set to
“HDMI/AV”.
(1) Check HDMI-HD/AV transmission
module connection.
(2) Power on the camera.
(3) Change the DJI Lightbridge App
video source to "HD Gimbal".
Appendix