Camera wiring/record control, Camera wiring, Record control – DJI Z15-BMPCC User Manual

Page 11

Camera Wiring/Record Control

Camera Wiring

An HDMI-HD/AV module converts the video signal format and transforms a TX signal into a record
control signal. Carry out the following procedures to connect the camera to the gimbal.

step1: Connect gimbal HDMI-HD/AV module to camera “HDMI OUT” with the AV video power

cable.

step2: Connect camera record control cable to the camera’s LANC REMOTE CONTROL port.
step3: Toggle the HD/AV Switch to the AV position if using a normal wireless video transmitter

module. Toggle the HD/AV Switch to the HD position if using a DJI HD wireless video
transmitter module.

Remove the camera from the gimbal before disconnecting the cable between the HDMI-HD/
AV module and camera.

Record Control

The Z15-BMPCC translates a TX command to a record control signal to start and stop a recording.
Set a 2-position switch/channel for remote record control.
Make sure the record control cable is correctly connected.
Whichever 2-position switch on your transmitter is selected, connect the right channel of receiver
to the AUX3 port. One of the two switch positions is to start recording and the other is to stop
recording.

Position-1 Position -2: Start recording

2-Positon
Switch

3-Positon
Switch

Position-2 Position -1: Stop recording

Camera Record Control Cable

AV Video Power Cable

Camera Wiring / Record Control