DJI Z15-BMPCC - Manual (Page 12)

12
©2014 DJI. All Rights Reserved.
Zenmuse Z15-BMPCC User Manual
When the AUX3 port is connected to a PPM channel, it is used as a PPM channel input.
The following diagram shows how the record control works.
If the record control works abnormally, check each step.
TX
2-Position Switch
TX Command TX Command TX Command
Wireless
RC Receiver
3-Pins Cable Internal Cable
HDMI-HD/AV
Module
Gimbal
Camera
GCU
Record Button
2-Position
Switch Channel
AUX3
Camera Record Control Cable
Video Signal Transmission
A wireless video transmission module is required for remote video.
A.AV Wireless Video Transmission
AV Video Power Cable
Wireless Video Transmission Module
Air Unit
Connect to the power source according to the
module’s voltage and current requirements.
ROLL
TILT
PAN
MODE
SHUT
AUX1
AUX2
AUX3
GCU GCU
Wireless Video
Transmission Module
Air Unit
Video Signal Port
G7
ROLL
TILT
PAN
MODE
SHUT
AUX1
AUX2
AUX3
GCU GCU
Yellow
Video Signal Port
G7
Power
Video Signal
GND
14V
52V
14V
52V
1
step1: Solder the corresponding Video Signal/GND cables to a wireless video transmission module
(Air Unit).
step2: Plug the AV video power cable lead into the GCU’s G7 port.
step3: Toggle the HD/AV switch to the AV position.
step4: Power on the gimbal. If the gimbal LED indicator blinks yellow it is functioning normally. If the
LED indicator shows solid yellow, the video signal is lost. Check the connections between
the camera and the HDMI video input.
Make sure to connect the wireless video transmission module to the GCU prior to
powering on.
The standard AV video power cable is recommended.
Make sure you solder the AV to the wireless video transmission module correctly. As the
cable carries power, ensure the cables are insulated or wrapped to prevent any type of short
circuit. Video signal is connected via"Yellow" line. GND is connected via "Brown" line.
Connect the wireless video transmission module to a power source as the GCU cannot supply
power. Make sure the power is a safe voltage for your own devices according to the wireless
video transmission module’s requirements.
Video Signal
Transmission