Flight test – DJI Z15-BMPCC User Manual

Page 21

Zenmuse Z15-BMPCC User Manual

Flight Test

step1: Ensure batteries are fully charged for your TX, GCU and all the other devices on your aircraft.
step2: Make sure all connections and wiring are in good condition.
step3: Switch on the TX.
step4: Adjust camera position on the roll axis of gimbal to level before powering on.
step5: Power on the gimbal and wait for the self initialization test to complete. The roll, yaw and

pitch axes will rotate quickly at the same time.

step6: After self initialization, the camera lens will point towards the aircraft’s nose and the three

axis gimbal should be in the position as illustrated in the above diagram.

step7: The gimbal goes into a second stage initialization. At this time the three axes will start to

rotate very slowly.

step8: The gimbal is at a standstill after initialization and ready to use.
step9: Toggle the assigned Working Modes switch on your transmitter and make sure it is working

properly.

step10: Switch the Working Modes to Non orientation-locked, FPV Mode (Reset), Orientation-

locked Mode respectively. Then try to push your sticks lightly in the Roll, Tilt and Pan
directions to feel if your gimbal moves in the corresponding directions. If not, go back to
the Gimbal Working Mode Switch Set to correct your settings.

If the gimbal is abnormal (unlike the diagram shows) after initialization, please refer to the

Trouble Shooting section in Appendix.

Pre -Flight Check