DJI A2 - Manual (Page 54)

©2013-2014 DJI. All Rights Reserved. 54
Recommended Mapping for Futaba Transmitter (Mode 2) User
Controller Unit Channel Receiver Channel Recommended Transmitter Switch
A Channe 1 (AIL) Joystick J1
E Channe 2 (ELE) Joystick J2
T Channe 3 (THR) Joystick J3
R Channe 4 (RUD) Joystick J4
U Channe 7 (AUX5) 3-Position switch, e.g. SG
K1~K6 Channe 5 (GEAR) Knob switch, e.g. LD, RD
Pitch Channe 6 (Vpp) Knob switch, e.g. LD, RD
D1/D3/D2 ---- ----
D4 Channe 9 (AUX1) 2-Position switch, e.g. SF
IOC Channe 10 (AUX2) 3-Position switch, e.g. SG
Go Home Channe 11 (AUX3) 2-Position switch with spring back function, e.g. SH
Gear Channe 8 (AUX4) 2-Position switch, e.g. SF
H3-2D Channe 12 （AUX5） Knob switch, e.g. LD、RD
Settings of gain values for Your Reference
To set the value of basic gain and attitude gain you can refer to the following diagram. These values are only for
reference and may vary in practice.
The Transmitter setup of FUTABA
Please configure the Frequency item on your Transmitter adhere to the table below. (The names of FASST modes
here are based to the Transmitter FUTABA T8FG, please ensure to select the most similar mode as the names
differs for different Transmitters)
Aircraft
Configuration Information Basic Attitude
Motor ESC Propeller Battery Weight Pitch Roll Yaw Pitch Roll Vertical
F450 DJI-2212 DJI-30A DJI-8 Inch 3S-2200 890 g 150 150 135 150 150 140
F550 DJI-2212 DJI-30A DJI-8 Inch 4S-3300 1530 g 170 170 150 160 160 150
S800 EVO/Z15 DJI-4114 DJI-40A DJI-15Inch 6S-15000 7000g 140 140 130 140 140 130
S1000/5D gimbal/
5D camera
DJI-4114 DJI-40A DJI-15Inch 6S-15000 9200g 120 120 120 170 170 120
S1000/5D gimbal/
5D camera
DJI-4114 DJI-40A DJI-15Inch 6S-15000 9300g 120 120 120 170 170 120