DJI A2 - Manual (Page 17)

©2013-2014 DJI. All Rights Reserved. 17
“RC
STATUS ”
description
Normal: the transmitter and receiver are linked and communicating well.
Disconnect: the A2 Flight Control System is powered on, but the transmitter is powered off.
RC-LOST: RC signal is lost (e.g. the transmitter is turned off after power on) or the receiver
is sending F/S signals (e.g. the aircraft flies out of the range which transmitter is
controllable).
The firmware version and the Assistant Software version should be matched when using the software
to configure the A2 flight control system, otherwise the software will not work. It’s recommended to
keep the firmware version and Assistant Software version up to date to avoid this issues.
1.2.3 Configure the control mode switch
Users should configure the control mode switch in the Assistant software in the following page. Only the control
mode switch has been set correctly, the control mode displayed in the left bottom corner will be the same to the
control mode pointed by the cursor on the channel U.
Configuration steps Exambles
Step 1.
Power on your Transmitter, map a 3-position
switch on the transmitter to the U channel of
Controller Unit as the control mode switch, of
which two positions are default as Atti. Mode
and GPS Atti. Mode and the third position is
optional, users can set as Atti. Mode or
Manual Mode.