DJI A2 User Manual

Page 18

Step 2.

Toggle the control mode switch to its three

positions, accordingly the cursor will move to

some control mode.

Step 3.

Power off the Transmitter, the FailSafe will be

enabled and the cursor will point to any area

out of the control modes.

Step 4.

If all steps above are realized, that indicates the

control mode switch is set successfully.

Important

In step 2, if the cursor doesn’t point to the correct control mode area (e.g. the following figures), that indicates

abnormal control mode switch configuration. Users must re-configure the Endpoint and FailSafe functions in the

Transmitter to make the cursor point to the right control mode and the according areas become blue.