DJI A2 User Manual

Page 38

Assign a 3-gear switch on the remote control for Cruise Control. Follow the steps below to use Cruise Control.

Use the control sticks to accelerate the aircraft to your target speed then toggle the assigned Cruise Control switch

to “Set” or “Continues”.

The action of three different gears of the cruise speed is defined as follow:



Deactivate Cruise Control.



Set

Move the switch to this position in flight to “Set” the cruising speed. The speed at the point that the switch is

toggled will be maintained. If you use the control sticks to adjust aircraft speed, the aircraft will return to its

original speed once the control sticks return to center.



Continues

In this position the aircraft will maintain its speed of flight however if you accelerate or slow down, it will

continue flying at the new speed once the control sticks return to center.

(1)

Cruise Control only works in GPS-ATTI mode (GPS > 6).

(2)

The aircraft will exit Cruise Control mode and hover at its current altitude when less than 6 GPS

satellites are detected, switches to ATTI. mode or enters auto go home mode. To enter“Set” and

“Continue” modes, you must first go into “OFF” mode.

(3)

Cruise Control is disabled during Banked Turn mode flying.

(4)

Maximum speed is 15m/s under Cruise Control mode.