Bully Dog 4038x Sensor Docking Station - Manual (Page 37)

36
Sensor Docking Station
O
2
Sensor Wiring
Bully Dog part number 40385 includes a cable which will
connect up to two Bosch oxygen sensors to the Sensor
Docking Station.
Connect the sensor(s) to one of the ports on the double-sided
end of the cable. Then connect the plug on the other side
of the cable to the Sensor Docking Station. Make sure that
the clips on the cable click closed. (Optional: To provide
extra protection to the oxygen sensor connection, spread a
reasonable amount of dielectric grease on the sensor cable
plug before connecting it to the Sensor Docking Station.)
The diagram below illustrates how the data gathered from the
connections on the Sensor Docking Station is displayed on a
GT or WatchDog:
P1 P2 AN1 AN2 AN3 F
- + + + Y+
PWR OXYGEN
R- Y+ R- - -
+5v
O
U
T
I
N
1 2
Sensor A
Sensor B
1. Displays as AF1 on the GT or WatchDog.
2. Displays as AF2 on the GT or WatchDog.
Single plug end of
O
2
Sensor Cable