Bully Dog 40440 GT for Jeep Quick Guide - Manual

C
:
PHYSICAL INSTALLATION 3.
Connect the adapter plug.
a. Find your vehicle’s diagnostic
port (OBDII) under the dash.
b. Connect the GT adapter plug
to the port.
c. Run the power cable from the
fuse box and connect it to the
adapter plug.
4.
Install the HDMI cable.
a. Slide the switch on the
adapter plug to “BATT”
b. Connect one end of the
HDMI cable to the adapter
plug.
c. Run the cable under the
dash or weather stripping.
1.
Locate a key-on fuse.
a. It only has power when
the key is in the “on” (or
“run”) position.
b. Use a 12 volt test light
or your vehicle owner’s
manual to locate one.
2.
Connect the
power cable.
a. Crimp the fuse
spade onto the
power wire.
b. Remove the fuse.
c. Slide the fuse tap
over one metal
prong of the fuse.
d. Slide the fuse spade
over the fuse tap
and put the fuse
back in the fuse
box.
OBDll Port Location
All OBDll ports are located under the dash on the drivers side of the vehicle.
5.
Mount and connect the GT.
a. Use the windshield
mount to attach the GT
head unit to the wind-
shield in a safe place.
b. Make sure not to ob-
struct the driver’s view.
c. Connect the HDMI cable
to the GT head unit and
then begin the pre-tune
checklist ( D ).
The black ground
wire inside the
power cable is not
required.
The key-on fuse should be
either a 10 or 15 amp fuse.
B
:
UPDATE YOUR GT 3.
Open the Update Agent
Launch the Update Agent
from the Windows Start menu
if it isn’t already open.
4.
Select your vehicle on
the Update Agent using the
“Change” button.
5.
Select “Update”.
Once the Agent indicates that the update is com-
plete, place the MicroSD card into your GT and
proceed with installing your GT ( C ).
1.
Install the Update Agent on
a Windows computer.
(
www.bullydog.com/update_agent.php )
2.
Plug in the card reader.
Plug the microSD card into
the reader, and plug the
reader into one of your
computer’s USB ports.
QUICK INSTALL GUIDE
GT for Jeep®
A
:
Adapter Plug Mini USB Cable Windshield Mount SD Card Reader SD Card
HDMI Cable Power Cable GT H ead U nit Fuse Tap Fuse Spade
PRE-INSTALL CHECKLIST
Confirm that you have all the parts listed
below, and then update your GT ( B ).
Tools You May Need:
Fuse Puller
Voltage Tester
Battery Charger
Pliers
Sensor Docking
Station
MORE GREAT
BULLY DOG
PRODUCTS
Accessories
More info on Bully Dog
products can be found
on our website at
bullydog.com
Not legal for sale or use in California on
pollution-controlled vehicles.